微波消解ICP-MS法测定宣威和富源土壤中的微量元素

建立了微波消解-ICP-MS法测定土壤中32种微量元素的方法。采用氢氟酸-硝酸-过氧化氢体系微波消解,稀释定容后用ICP-MS对溶液进行元素的测定,在优化仪器工作参数后,以双内标铑(Rh)和铼(Re)进行校正。元素检出限为0.01～0.45ng/ml,测定国家标准物质西藏土壤成分分析标准物质GBW 08302中的元素,测定值与标准值或参考值基本一致,用该法测定云南宣威和富源两地24份土壤样品结果表明,该方法快速、简便、准确,适于土壤中多种微量元素的测定。     

Comparison of two sample preparation methods for analysis of organochlorine pesticides residues in fish muscle

The aim of this study was to compare recoveries of organochlorine pesticides (heptachlor, α-HCH, β-HCH, γ-HCH, op′-DDD, pp′-DDD, pp′-DDE, op′-DDT, pp′-DDT) from fish muscle dried by two alternative methods: (i) grinding with anhydrous sodium sulphate and (ii) freeze drying. Pesticide residues content was determined by gas chromatography-mass spectrometry (GS-MS) method. For four pesticides (γ-HCH, α-HCH, heptachlor and pp;-DDD) in four of five fish species, higher recoveries were obtained from the freeze-dried samples. For five remaining pesticides, correlations between fish species and drying method were not found. The results of this study do not clearly indicate which drying method caused lower losses of analytes. Recoveries from the freeze-dried samples ranged from 69.9 to 117.6 %, while recoveries from the samples ground with sodium sulphate varied from 64.4 to 126.7 %. Either of the methods gave satisfactory recoveries and they both can be used interchangeably.     

高性能木材干燥测控系统的研制

在木制品生产行业中，木材干燥是木制品加工生产工序中的一个重要环节，而在木材干燥生产中突出的问题是木材变形、开裂、木材含水率不均匀和霉变、虫蛀等。针对上述问题，设计出以高性能AVR微控制器为核心，应用恒流源、高分子湿敏电容和动态补偿等技术的全自动木材干燥测控系统。实验结果表明，木材干燥测控系统能保证产品质量，提高生产效率，硬件可靠性高，有工程实用价值。     

微波消解-石墨炉原子吸收法测定小麦中钴

利用微波消解-石墨炉原子吸收法检测小麦样品中的低含量钴，方法简单、操作便捷，测定结果精确度和准确度好。钴的线性回归方程为A=0．003303c＋0．004218，测定结果的相对标准偏差为4．1％（标准样品ESP-1）和1．1％（6#小麦样品），检出限为0．005mdkg。     

高温生物滤塔处理污泥干化尾气的研究

利用高温生物滤塔处理污泥干化产生的尾气,气体处理量为2 700~3 100 m~3·h~(-1),停留时间为21.88~25.10 s,研究启动期和稳定运行的运行效果.生物滤塔能有效去除干化尾气中的SO_2、氨以及挥发性有机物,去除率分别达到100%、93.61%以及87.01%.微生物分析结果显示,生物滤塔内形成稳定的生物系统,填料和溶液中生长一定量的细菌和硫细菌.主要功能种群包括类芽孢杆菌Paenibacillus sp.,螯台球菌Chelatococcus sp.,芽孢杆菌Bacillus sp.,梭菌Clostridium thermosuccinogerws,假黄单胞菌Pseudoxanthomonas sp.,地芽孢杆菌Geobacillus debilis.大部分为脱氮、脱硫或者降解挥发性有机物的嗜热菌.     

Kinetics of Solvent Blue and Reactive Yellow removal using microwave radiation in combination with nanoscale zero-valent iron

We investigated the efficiency and kinetics of the degradation of soluble dyes over the p H range 5.0–9.0 using a method employing microwave radiation in combination with nanoscale zero-valent iron(MW–n ZVI). The n ZVI particles(40–70 nm in diameter) were prepared by a liquid-phase chemical reduction method employing starch as a dispersant.Compared to the removal of Solvent Blue 36 and Reactive Yellow K-RN using only n ZVI,more rapid and efficient dye removal and total organic carbon removal were achieved using MW–n ZVI. The dye removal efficiency increased significantly with decreasing p H, but was negligibly affected by variation in the microwave power. The kinetics of dye removal by MW–n ZVI followed both an empirical equation and the pseudo first-order model, while the kinetics of dye removal using n ZVI could only be described by an empirical equation. It was also concluded that microwave heating of the dye solutions as well as acceleration of corrosion of n ZVI and consumption of Fe(II) were possible reasons behind the enhanced dye degradation.     

Microwave cladding: A new approach in surface engineering

Cladding is generally characterized by partial dilution of the substrate and hence formation of metallurgical bonding between the substrate and the deposits. Laser cladding is one of the most widely practiced surface engineering techniques. The present work mainly focuses on a novel development in surface engineering techniques in the form of microwave cladding. Clads of tungsten carbide (WC) based WC10Co2Ni powder on austenitic stainless steel were produced using microwave hybrid heating. Microwave clads were developed by exposing the preplaced, preheated powder for a duration of 120 s to microwave radiation at 2.45 GHz frequency and 900 W power in a home microwave system. Characterization of the clads was carried out in the form of microstructural and elemental composition studies. Investigations show crack-free interface revealing good metallurgical bond associated with partial dilution of the stainless steel substrate and full melting of WC particles. Typical X-ray diffraction results confirm presence of metallic carbides in the clad which is primarily responsible for significantly higher microhardness of the clad. Process mechanism has been discussed.     

微波消解-双道原子荧光分析仪联合测定土壤中砷和汞

应用AFS-9530型双道原子荧光光谱法研究土壤样品中砷和汞的联合测定技术,将土壤样品置于(1+1)王水的微波消解体系中进行消解,加入1m L 5%的重铬酸钾溶液保护汞,加入5m L(5%硫脲+5%抗坏血酸)混合液将五价砷还原为三价,以硼氢化钾为还原剂在5%盐酸介质中测定砷和汞,最低检出限为砷0.55μg/L,汞0.30μg/L,回收率砷在93.5%—105.8%之间,汞在85.5%—104.9%之间,满足准确度要求。     

污泥中汞的存在形态及其在干化过程中的动态变化

在测定市政污泥、印染污泥和造纸污泥中汞含量及其存在形态分布特征的基础上,通过模拟实验,系统研究了不同类型污泥中汞存在形态在干化过程中的动态变化,同时分析了污泥中汞含量和各存在形态发生变化的原因.结果表明,市政污泥的汞含量依次大于印染污泥和造纸污泥;污泥中无酸溶态汞和可还原态汞,只存在可氧化态汞和残渣态汞;被试污泥在25~100℃干化时,含水率降低不会导致汞的析出;在100~200℃干化时,污泥中汞含量随温度的升高呈现出缓慢降低的趋势;当干化温度200~300℃时,随污泥中有机质和硫化物的分解,可氧化态汞消失;当干化温度达到400℃时,污泥中汞不复存在.     

Degradation of anionic surfactants during drying of UASBR sludges on sand drying beds

Anionic surfactant (AS) concentrations in wet up-flow anaerobic sludge blanket reactor (UASBR) sludges from five sewage treatment plants (STPs) were found to range from 4480 to 9233mgkg(-1)drywt. (average 7347mgkg(-1)drywt.) over a period of 18 months. After drying on sand drying beds (SDBs), AS in dried-stabilized sludges averaged 1452mgkg(-1)drywt., a reduction of around 80%. The kinetics of drying followed simple first-order reduction of moisture with value of drying constant (k(d))=0.051d(-1). Reduction of AS also followed first-order kinetics. AS degradation rate constant (k(AS)) was found to be 0.034d(-1) and half-life of AS as 20 days. The order of rates of removal observed was k(d)>k(AS)>k(COD)>k(OM) (drying >AS degradation>COD reduction>organic matter reduction). For the three applications of dried-stabilized sludges (soil, agricultural soil, grassland), values of risk quotient (RQ) were found to be <1, indicating no risk.